Hi all, me again. This time I just wanted to show something I made for my desk last week. I was recently browsing through the Teddy Bo Challenge blog, and they had a few new releases, including a bear covered in Post-It notes. Debbie Dunn on the design team showed a fab Post-It holder and I knew I just had to have the image and make my own!
Somebody asked me if it was easy to make, so I have quickly put together another just to demonstrate.
I started with one of the images from the Tabs Collections that I had already coloured.
I trimmed the image down and matted onto some blue cardstock using 3D foam.
I then measured a length of red card slightly wider then the image to use as my base. My Post-It pads for this project are approximately the same with as the image, so I know they will fit.
I then folded and scored the image in half, and then half again on one section, so it looks a bit like this:
I then folded and scored the image in half, and then half again on one section, so it looks a bit like this:
I then secured the image to the base using double sided tape (only on the bottom half though, as the rest will be the easel) and secured the Post-It block also using double sided tape, and there you have it, one finished Post-It Holder
I am entering this into Teddy Bo - Anything Goes
Ooooo well done you! I still need to make one of these for my desk at work :0) Bo looks so cute and I love the tut :0)
ReplyDeleteThanks for sharing it with us at Teddy Bo's Anything Goes Challenge and good luck :0)
Love Clairebears x
Superb work, very nice creation !
ReplyDeleteThanks for joining us at the Teddy Bo's challenge !
xx
Fabulous! glad Debbie inspired you and you decided to have a go, fabulous colouring on both post-it note holders.
ReplyDeleteThanks for playing along at Teddy Bo, good luck, Colette xx
Woooow!!! Stunning work dear! =)
ReplyDeleteThanks for playing along at TeddyBo this time
Hugs Maritha
Wow Gorgeous creation!! Thank you for sharing your wonderful work with us at Teddy Bo's Challenge! Woo x
ReplyDelete